8. MDM Targets

In this section you must configure the ideal production times of your machines.

Let's get started!

First we will configure the objectives of the work center where it indicates the number of units that must be produced per hour.

1. Add a work center target on the "+"

2. Select the work center

3. Indicates the number of units produced per hour in the selected work center.

Then you must establish objectives like the work center but for each previously created shift. They are the objectives of each shift where it indicates the number of units that should be produced per hour.

1. Add a work center target on the "+"

2. Select an operation

3. Select a work shift

4. Indicates the number of units produced per hour in the selected shift.

As a third step, you will get a summary of all the units that must be produced in an operation in each shift, each special day, that is, special days, closed days or days where the objective production will not be equal to the ideal one due to events or occasions. specials. There you can edit or delete the objectives of those turns. You also have two buttons, one to reset all the information and another to reload it.

Finally, you must define the objectives OEE is an international percentage indicator to measure the productive efficiency of work centers.

Example: Low Yield 40%, Intermediate Yield 70%, High Yield 100%

1. Add an OEE objective for each work center the "+"

2. Select a work center

3. Set the target according to the colors in %.

Green: High performance (%)

Yellow: Intermediate performance (%)

Red: Low performance (%)

Ready, We know that is a lot of information but little by little you finish configuring your MES system.